![]() ![]() You only need them seated deeply enough that the bullet will not:Ī) Be jammed into the throat, which raises pressure.ī) Won't come loose and fall out, with the exception described below. The reason that you don't shallow seat is to enhance accuracy by allowing the bullet to move a little more upon initial firing so that it reaches the lands with a bit of steam behind it, if it leaves the neck early, it can have enough time to tip before it engages the lands, which will ruin accuracy. The difference in COL probably won't make much difference to accuracy, as long as it feeds without moving in the case, you'll probably get good accuracy. I have gotten away with shallower seating, but you need to have a tight grip on the bullet to do this.ġ/8" is a little shallow, but if you can't push the bullet in once seated by pushing the tip of the bullet against the edge of your loading bench, all's good! General rule of thumb is to seat your bullets at least one calibre deep. Do They Need To Go To Where The Neck Meets The Shoulder. What I Need To Know What Is The Least They Need To Seated Into The Neck. ![]() The Problem With The 60 And 80 Grain Is Not Oal Because Even If You Only Seat Them. Originally Posted by 2433006300 View Post ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |